Abstract:To address the low development efficiency of heavy oil cold production in the Kexia Formation of Block Si-2 in Xinjiang Oilfield, a set of viscosity-reducing composite oil displacement system for heavy oil cold production was optimized and constructed by conducting basic physical property analysis on heavy oil samples from this block and focusing on key performance indicators including viscosity reduction performance, interfacial tension, wettability improvement and emulsion stability. Its optimal formula is: LAS (0.2%) + CUS (0.05%) + polymer (1500 mg/L). The performance evaluation results showed that the composite system could reduce the oil-water interfacial tension to the order of 10?³ mN/m, with a crude oil viscosity reduction rate as high as 98.83%. Laboratory physical simulation experiments indicated that under the condition of a composite system injection volume of 0.5 PV, the oil recovery factor was increased by 21.96% compared with primary water flooding after the processes of composite flooding and subsequent water flooding. To further improve the field applicability of the system, injection parameter optimization experiments were carried out to systematically investigate the effects of injection mode, injection concentration, injection volume and injection rate on oil displacement efficiency. The results demonstrated that the optimal injection mode was the mixed injection of viscosity reducer and polymer; the optimal injection concentration of polymer was 1500 mg/L; the economically effective injection volume was 0.5 PV; and the optimal injection rate was 0.2 mL/min, which is converted to a field single-well injection rate of 21.6 m³/d. This study not only provides theoretical reference and technical reference for the optimal design of heavy oil viscosity-reducing composite oil displacement systems, but also offers strong technical support for the heavy oil cold production test scheme of Block Si-2 in Xinjiang Oilfield.