适用于聚合物驱后油层的聚表剂研制与性能评价
CSTR:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

中国石油天然气集团有限公司 “ 中高渗油田特高含水期大幅度提高采收率技术研究 ” (项目编号 2023 ZZ 22)。


Preparation and Property Evaluation of Polymeric Surfactant Suitable for Oil Layers after Polymer Flooding
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    为高效挖潜大庆油田一类油 层聚合物驱后约 44 % 的剩余油储量,以丙烯酰胺、N - 十二烷基丙烯酰胺、2 - 丙 烯酰胺基 - 2 - 甲基丙磺酸和十二烷基聚氧乙烯 (23) 醚丙烯酸酯为单体,采用自由基水相聚合后水解的方法,制备 了一种适用于聚合物驱后油层的聚合物表面活性剂 (聚表剂 A)。对比评价了聚表剂 A 与商品化聚表剂 HB 和部 分水解聚丙烯酰胺 HPAM 驱油剂的溶液性能、注入能力和驱油效果。结果表明,聚表剂 A 的基础理化性能满足 相关技术标准,质量浓度 1000 mg/L 下,现场污水配制聚表剂 A 溶液黏度为 52 . 7 mPa · s,质量分数 1 . 0 % NaCl 溶液 中黏度保留率为 58 . 9 %,90 d 老化黏度保留率为 63 %,相同条件下的增黏性、抗盐性、老化稳定性等优于对比聚合 物驱油剂。聚表剂 A 可降低油水界面张力,与原油形成 O/W 型乳液,24 h 乳化析水率低于 4 %,满足聚合物驱后 油藏需求。在聚表剂 A 质量浓度为 1000 mg/L、注入量为 0 . 5 PV 的条件下,天然贝雷岩心驱油实验聚合物驱后可 提高采收率 15 . 1 个百分点,较聚表剂 HB 和 HPAM 分别高出 3 . 3 和 5 . 3 个百分点。聚表剂 A 可大幅提高原油采收 率,满足聚合物驱后油藏高效开发的需求。

    Abstract:

    To effic iently exploit the approximately 44 % remaining reserves in the main oil layers of Daqing oilfield after polymer flooding,a polymeric surfactant was prepared using acrylamide (AM),N -dodecyl acrylamide,2 -acrylamido- 2 - methylpropanesulfonic acid and dodecyl polyoxyethylene (23) ether acrylate as reaction monomers by free-radical aqueous polymerization followed by weak alkaline hydrolysis. The solution properties,injectability,and oil recovery performance of polymeric surfactant A was investigated,compared with commercial polymeric surfactant HB and partially hydrolyzed polyacrylamide (HPAM) oil displacement agents. Results demonstrated that the fundamental physicochemical properties of polymeric surfactant A met the relevant technical standards. At a concentration of 1000 mg/L,the viscosity of polymeric surfactant A solution prepared with on-site wastewater solution was 52 . 7 mPa · s. In 1 . 0 % NaCl solution,the viscosity retention rate was 58 . 9 %,and after 90 days of aging,the viscosity retention rate was 63 % . Under identical conditions,its viscosity-enhancing capability,salt resistance,and aging stability outperformed those of the comparative polymers. Polymeric surfactant A could reduce oil-water interfacial tension and form an "O/W" (oil-in-water) emulsion with crude oil. After 24 hours,the water separation rate of emulsion was below 4 %,meeting the post-polymer flooding reservoir requirements. In the natural Berea sandstone core oil displacement experiment at a concentration of 1000 mg/L and injection amount of 0 . 5 PV,the enhanced oil recovery after polymer flooding was 15.1 percentage point,which was 3.3 and 5.3 percentage points higher than that of HB and HPAM. Polymeric surfactant A could significantly enhance oil recovery,meeting the needs for efficient development of reservoirs after polymer flooding.

    参考文献
    相似文献
    引证文献
引用本文

曹瑞波,皮彦夫,潘 峰,李 勃,闫 伟.适用于聚合物驱后油层的聚表剂研制与性能评价[J].油田化学,2026,43(3):491-501.
CAO Ruibo, PI Yanfu, PAN Feng, LI Bo, YAN Wei. Preparation and Property Evaluation of Polymeric Surfactant Suitable for Oil Layers after Polymer Flooding[J]. OILFIELD CHEMISTRY,2026,43(3):491-501.

复制
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2026-10-30
  • 出版日期:
文章二维码
点击这里给我发消息

点击这里给我发消息